As the mould is closed before the rubber
charge is forced into it, closer dimensional control is achievable. In the
transfer process, fresh rubber surfaces are produced & this allows
development of a strong rubber-metal bond with any insert in the mould. Unit
production costs are lower due to shorter cure times as a result of heating
the rubber due to flow through sprue, runner & gates & shorter
downtime between guns, as only one charge blank is necessary, even if a
multi cavity mould is used. Special screw mechanism preventing rubber strip
rupture during feeding. Accurate temperature control at all areas before
injection. Some of the benefits of Transfer and Injection Moulding Presses
are as follows: